Shopping Cart
NeonGrand led neon sign User Manual

NeonGrand Led Neon Sign User Manual

NeonGrand Led Neon Sign User Manual contains all the basic instructions you need to follow when installing and operating a led neon sign.

PRODUCT INFORMATION

  • Power Consumption: 3W 
  • Power use: 110-220V~50/60Hz 
  • Warranty period: 12 months 
  • Uses: Night lights, decorative lights 
  • Manufacturer: NeonGrand 
  • Website: https://neongrand.com/

INSTALLATION OPTIONS

Option 1: Using Mounting Screws (Drill Required!)

  • Step 1: Place the neon sign flat up against the intended wall or space.
  • Step 2: Use the marker or pen to mark the pre-drilled holes’ position on the wall.
  • Step 3: Put away the sign on a safe surface to avoid scratching the acrylic backing.
  • Step 4: Next, use a drill and a small drill bit, make the pilot holes using the guides you’ve just marked out. If you’re drilling into drywall, you can add the drywall anchors to make sure your neon sign will be securely held in place.
  • Step 5: Position your neon sign against the wall and use the hardware to secure it in place, tightening the screws if need be. 
  • Step 6: Plug the sign in and chill.

Option 2: Using our hanging wires (Drill Required!)

  • Step 1: Measure out how far down you want your sign to hang. 
  • Step 2: Use pliers to cut each wire to the desired hang length – leave a little extra (2.5in) for the crimped loop that will hold the sign.
  • Step 3: Attach the wires to the mount by pushing down on the spring powered mouth of the mount and feeding the wire in – release the mouth and the wire will grip and be stuck firmly in the mount.
  • Step 4: Use the super small double barrel ferrules (or crimps) to place one on the end of the wire, place the wire through the hole of the sign, loop the wire around the sign and stick it back through the small metal crimp. Use the plier and squish the metal crimp horizontally across to lock it in. Repeat this for the other hanging wires.
  • Step 6: Plug the sign in and chill.

NOTE

  • Remove the insulating paper from the Neon light before use. 
  • DO NOT change the source yourself. 
  • NeonGrand is absolutely not responsible for problems not caused by the manufacturer or due to errors from the above note.
  • If there are any problems, please contact NeonGrand directly for further support.
Leave a Reply

Your email address will not be published.